1. Remove stock seat cover completely.
2. You may have to remove foam from tray.
3. Waterproof seat with plastic. (trash bag works well)
4. Poke holes where pull tabs go.
5. Align seat cover on seat.
6. Push tabs through seat holes.
7. Lay your JETTRIM cover over the seat.
8. Find the center point in front of your seat. Match it to the center of your seat cover. Using your staple gun, apply 4 to 5 staples into what is called the “listing”. The listing simply is the material that runs around the whole outside perimeter of you seat cover and where your staples are applied.
9. Move to the front corners of your seat and staple to secure each corner while keeping in mind the stretch factor.
10. Move to the rear of your seat and stretch your seat cover over the back. Stretching is very important, so take your time to insure proper installation.
11. After you have properly stretched your seat cover, secure it by stapling the center then the rear corners of your seat cover.
12. Move back to the front of your seat again, focusing on the wings (bottom front part of your seat). Stretch evenly from side to side and secure with staples.
13. Secure all of your excess material found in all corners. Just like wrapping a present.
14. Once all the corners are secure, everything else, with minimal stretching will fall into place.
15. Don’t be afraid to use extra staples to secure your seat cover.